Ball grid array-Disadvantages-Difficulty of inspection-electronic pcb assembly

- Jan 07, 2017-

Ball grid array-Disadvantages-Difficulty of

inspection-electronic pcb assembly

Disadvantages

Difficulty of inspection

Once the package is soldered into place, it is difficult to find soldering faults. X-ray machines, industrial CT scanning machines, special microscopes, and endoscopes to look underneath the soldered package have been developed to overcome this problem. If a BGA is found to be badly soldered, it can be removed in a rework station, which is a jig fitted with infrared lamp (or hot air), a thermocouple and a vacuum device for lifting the package. The BGA can be replaced with a new one, or it can be refurbished (or reballed) and re-installed on the circuit board. Pre-configured solder balls matching the array pattern can be used to reball BGAs when only one or a few need to be reworked.

Due to the cost of visual X-ray BGA inspection, electrical testing is very often used instead. Very common is boundary scan testing using an IEEE 1149.1 JTAG port.

A cheaper and easier inspection method, albeit destructive, is becoming increasingly popular because it does not require special equipment. Commonly referred to as dye and pry, the process includes immersing the entire PCB or just the BGA attached module into a dye, and after drying, the module is pried off and the broken joins are inspected. If a solder location contains the dye, then it indicates that the connection was imperfect.


Professional Manufactur Custom Design Circuit Board Electronic Pcb


Previous:Ball grid array-Disadvantages-Difficulties with BGAs during circuit developmen Next:Ball grid array-Disadvantages-Design Circuit Board Electronic Pcb​