Custom Design Circuit Board Electronic Pcb​-Breadboard-Terminal strips

- Dec 28, 2016-

Custom Design Circuit Board Electronic

Pcb-Breadboard-Terminal strips

Bus and terminal strips

Solderless breadboards are available from several different manufacturers, but most share a similar layout. The layout of a typical solderless breadboard is made up from two types of areas, called strips. Strips consist of interconnected electrical terminals.

Breadboard consisting of only terminal strips but no bus strips
Terminal strips

The main areas, to hold most of the electronic components.

In the middle of a terminal strip of a breadboard, one typically finds a notch running in parallel to the long side. The notch is to mark the centerline of the terminal strip and provides limited airflow (cooling) to DIP ICs straddling the centerline. The clips on the right and left of the notch are each connected in a radial way; typically five clips (i.e., beneath five holes) in a row on each side of the notch are electrically connected. The five rows on the left of the notch are often marked as A, B, C, D, and E, while the ones on the right are marked F, G, H, I and J. When a "skinny" dual in-line pin package (DIP) integrated circuit (such as a typical DIP-14 or DIP-16, which have a 0.3-inch (7.6 mm) separation between the pin rows) is plugged into a breadboard, the pins of one side of the chip are supposed to go into row E while the pins of the other side go into row F on the other side of the notch. The columns are numbered 1 - 50 or whatever number of columns there are.


Professional Manufactur Custom Design Circuit Board Electronic Pcb


Previous:Custom Design Circuit Board Electronic Pcb​-Electronic packaging Next:Design Circuit Board Electronic Pcb​-Breadboard-Solderless breadboard