TopoR General information Printed circuit board

- Mar 28, 2017-

TopoR General information Printed

circuit board

General information

Wires consisting of lines only
Wires consisting of lines and arcs

Routing of the wiring topology is done automatically and flexibly; angles are not limited to 90° and 45°.

Efficient use of PCB space and absence of preferred routing directions in layers considerably reduces electromagnetic crosstalks.

TopoR routes all connections, even if this entails violating design constraints. Such violations can be automatically corrected later.

When you move objects (such as components and vias) around, wire length and shape are optimized automatically with appropriate clearance.

The user is free to choose from two ways to calculate the wire shape: with or without arcs. The first method involves wires consisting of lines only. The other makes wires keep appropriate clearance when circling pads and consist of arcs and lines.

TopoR simultaneously optimizes several alternative variants of the layout. Variants with the worst parameters (total wire length and number of vias) will be removed.

TopoR has an automatic component placement feature. The procedure can be used both for all components of the board and only for components in a specific area. It is not comparable to the quality of the manual placement, but it can be used as a preparation step for manual placement.

The minimum and desired clearances for each net can be specified.

Reduced wire width

TopoR automatically reduces the width of a wire that approaches a narrow pad (or one with a diameter that is less than the width of the wire), or when it passes through bottlenecks (for example, between the pads of a component).

Wire-to-pad transitions use teardrop-style smoothing. The use of this procedure at the design stage helps avoid violations in design-rule checking when teardrops are added in the CAM editor.

BGA component routing

TopoR can recognize BGA (Ball Grid Array) component areas and apply a special strategy for routing them. This helps reduce the number of vias, the density of connections, and in some cases the number of routing layers.

In Russian (language of the developers), topor means "axe".


Previous:Wave soldering with Printed circuit board Next:TopoR and TopoR's History with Printed circuit board